Model 196LRC features tapered rollers to maintain product orientation. Reversible, it is also commonly slave driven from 196VP and 796CALR conveyors.
Specifications
| Tread Rollers | 2-1/2″ dia. to 1-11/16″ dia. x 14 ga. steel tapered rollers, model 254T; 1.9″ dia. x 16 ga. steel straight tangent rollers, model 196S. |
| Pressure Sheaves | Provides drive belt pressure to upper tread rollers. |
| Belting | “B” section V-belt. |
| Take-Up | Screw type adjustable sheave with flat idler sheaves to maintain belt tension. |
| Tangents | 12″ opposite spur end on 60/30 unit; 18″ opposite spur end on 45/45 unit. |
| Bed | 7″ x 1-1/2″ x 12 ga. formed steel channel frame. |
| Bearings | End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings. |
| Roller Chain | Drive shaft is driven by No. 50 chain. |
| Floor Supports | Optional |
| Motor Drive | 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor, located at infeed end of curve below bed. |
| Drive Location | Drive located on outside of curve. Specify left hand tangent length, right hand tangent length and drive location (“left hand drive” or “right hand drive”). NOTE: Drive hand determined with reference point located at outside of curve. For models slave driven (less drive), specify drive shaft location. |
| Capacity | 500 lb. total distributed live load. |
| Speed | 60 FPM, constant. |
| Electrical Controls | Optional |
 |
 |