Roach 796CALR is ideally suited for side loading, unloading or temporary accumulation. Its unique cam allows tread roller drive pressure to be adjusted in only seconds.
Specifications
| Tread Rollers | 1-.9″ dia. x 16 ga. steel rollers, model 196S. |
| Pressure Rollers | .9″ dia. x 16 ga. steel, model 196S, cam adjustable. |
| Belting | 6″ wide black PVC-120 COS. |
| Center Drive | Reversible drive with 24″ integral belt take-up. For units under 8′-0″ overall length, drive components must be stacked. Consult factory for minimum unit elevation. |
| Squaring Rods | Adjustable rods on underside of bed allow frame to be squared for improved belt tracking and are standard on all units over 30′. |
| Drive Pulley | 4″ dia. with 1-3/16″ dia. shaft or 8″ dia. with 1-7/16″ dia. shaft; both crowned and fully lagged. |
| End Pulley | 4″ dia., crowned, with 1-3/16″ dia. shaft. |
| Return Rollers | 1.9″ dia. x 16 ga. steel, model 196S |
| Bed | 6″ x 1-1/2″ x 12 ga. channel frame slotted for tread rollers to pop-out. When unit is installed at 7′-0″ elevation or higher, rollers must be retained in conveyor frame. Specify desired elevation. Bed sections attached with couplings and floor supports. |
| Floor Supports | SM-6 adjustable 31-1/2″ to 43-1/2″ TOR. Supports should be lagged to floor. |
| Bearings | All pulley bearings are precision, heavy duty, lubricated, ball bearing units with cast iron housings. |
| Roller Chain | Drive pulley is driven by No. 50 roller chain for 1-1/2 HP or less and No. 60 chain on larger drives. Chain take-up provided on motor base. |
| Motor Drive | 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor. |
| Speed | 60 FPM, constant. |
| Electrical Controls | Optional |
 |
 |