Model 796LSZ is one of the most popular accumulators in the unit handling industry. This zero pressure line shaft driven accumulator is ideal for numerous light to medium duty applications. Curves, spurs and other line shaft modules may be driven by a SINGLE drive.
Specifications
| Tread Rollers | 1.9″ dia. x 16 ga. steel, model 196S grooved |
| Pressure Rollers | 3/16″ dia., polyurethane belts. Nominal 15 lbs. per roller drive. |
| Drive Shaft | 1″ dia. C1018 cold rolled steel shaft. |
| Couplings | Couplings located both ends (type “A”), one end only (type “B” or “C”) or none (type “D”). |
| Center Drive | Located approximately 16-1/2″ from end of bed section on 4″ RC; 18″ on 3″ and 6″ RC. |
| Bearings | All pulley bearings are precision, heavy duty, lubricated, ball bearing units with cast iron housings. |
| Accumulation | 2′-0″ zone length, pneumatically actuated, zone singulation operation. |
| Speed | 60 FPM, constant. |
| Bed | 7″ x 1-1/2″ x 12 ga. formed steel channel frame. Bed sections attached with splice plates and floor supports. |
| Floor Supports | Optional |
| FRL | Unit is provided with filter, regulator, lubricator with 1/4″ ports. |
| Pneumatic Actuation | Maximum air line pressure should not exceed 30 PSI. |
| Motor Drive | 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor. |
| Roller Chain | Drive shaft is driven by No. 50 chain. Chain take-up provided on motor base. |
| Electrical Controls | Optional |
 |
 |